Tool for even and quick application of glue on polystyrene (or styrodur XPS) etc.
Complete set ready to work.
Much faster application of glue on polystyrene than the traditional method!
The entire polystyrene board (or XPS) covered with glue precisely and evenly (devices for applying glue to the floor and the tile are also available in a separate offer).
Smooth regulation of the amount of glue (comb height, applied layer thickness): from a 20x15 mm comb to 0x0 (smooth).
Easy to use (assembly requires only a screwdriver).
Easy to wash.
Safe for transport (all edges except the teeth are rounded).
Durable, strong and rigid structure.
Before starting work
Place the device on a flat surface that can be tightened (OSB, GK, wooden top, etc.)
Set the width of the device (max 60 cm) by setting polystyrene between the sides of the device, adding 1 mm of play, so that it moves freely (front, back)
Screw the device to the base (fixing screws are not included).
Set the height of the comb above the polystyrene so that it does not come into contact with it during operation (two 1 mm feeler gauges for easy adjustment of the standard comb height above polystyrene (1 mm) included in the kit.
If the layer of applied adhesive on polystyrene is to be applied with a 20x15 mm comb, the smooth spreader can be lifted completely up or dismantled.
If the layer of adhesive applied on polystyrene is to be smooth, the overlay should be completely lowered over the comb, covering the teeth.
60 cm [~24" (in)]
Acid-resistant stainless steel sheet
Place of production
Adhesive layer width (min-max)
min 0 cm - max 60 cm
Maximum thickness of the polystyrene board
max 20 cm
The dimensions of the teeth of the comb (smooth adjustment)