Device for equal and fast application of adhesive on the tiles

Device for equal and fast application of adhesive on the tiles | stone | clinker | parquet | polystyrene (Styrodur XPS) etc.

Much faster glue application on the tile than the traditional method! 100 m² (and more) in one day - now possible!

• Complete set for the tiler ready to work.
• Entire surface thoroughly covered with adhesive of uniform thickness. (Appliances for applying adhesive to the floor in a separate offer).
• Tile levelling reduced to a minimum.
• Infinitely adjustable amount of glue (comb height, thickness of layer applied).
• Easy to use (assembly requires only a screwdriver).
• Adjustable toothed trowel for glue easy to clean.
• Safe to transport (all edges except teeth rounded).
• Durable, strong and rigid construction.

Before starting work

1. Fix the unit to a flat surface that can be tightened and that will not scratch the tile (OSB, wooden plywood, plasterboard, wooden top, etc.).
2. Align (tighten) the sides of the unit to the substrate maintaining a minimum clearance between the tile (fixing screws included).
3. Position (tighten) the comb over the tile. Place the comb on the 1 mm gap gauges (gap gauges included) before tightening.
4. If applying glue to the tile with the comb - set in the upper position or remove the comb stiffening bar.
5. If applying the adhesive to the tile "smoothly" - lower the comb stiffening strip (remember 1mm gap above the tile).
6. Once all screws are tightened, the plate should move freely back and forth.
7. Tighten the lower comb locks.