Tool for even and quick application of glue on ceramic tiles | porcelain stoneware | stone | parquet | polystyrene (styrodur XPS), etc.
Complete set ready to work.
Much faster glue application on the plate than with the traditional method!
The entire tile (polystyrene, stone, parquet board) is carefully covered with glue of the same thickness. (devices for applying glue to the floor are also available in a separate offer).
Tile leveling reduced to a minimum
Smooth adjustment of the amount of glue (comb height, applied layer thickness): from a comb 8x8 mm to 0x0 (smooth).
Easy to use (assembly requires only a screwdriver).
Easy to wash.
Safe for transport (all edges except the teeth are rounded).
Durable, strong and rigid structure.
No work on the knees.
Before starting work
Place the device on a flat surface that will not scratch the tile and with the possibility of tightening (OSB, GK, wooden top, etc.)
Set the width of the device by setting the plate between the sides of the device after adding 1mm of play, so that the plate moves freely (front, back)
Screw the device to the base (fixing screws are not included).
Set the height of the comb above the plate so that it does not come into contact with it during operation (two 1mm feeler gauges for easy adjustment of the standard comb height above the plate (1mm) included in the kit.
If the layer of applied adhesive on the tile is to be applied with an 8x8 mm comb, the smooth grease cap can be lifted completely up or dismantled.
If the layer of adhesive applied on the plate is to be smooth, the overlay should be completely lowered over the comb, covering the teeth.
Acid-resistant stainless steel sheet
Place of production
The width of the applied adhesive layer (NetYou II 600)
min 0, max 60 cm
The width of the applied adhesive layer (NetYou II 800)
min 0, max 80 cm
The minimum dimensions of the teeth of the comb (continuously adjustable)
min 0x0 mm (smooth lubrication of the plate)
The maximum dimensions of the teeth of the comb (continuously adjustable)
max 8x8 mm
Thickness of the applied adhesive (tooth height above the plate):
min 0 max approx 30 mm (depending on the thickness of the tile)