Device for equal and fast application of adhesive on the tiles

A device for quick and even application of glue on ceramic tiles, stoneware, clinker, stone, parquet, polystyrene, XPS polystyrene, etc.

Much faster application of glue on the tile than the traditional method! Over 100 m² in one day - now it's possible!

• A complete set for the tiler ready to work.
• The entire surface is thoroughly covered with glue of the same thickness. (devices for applying glue to the floor in a separate offer).
• Tile leveling reduced to a minimum.
• Smooth regulation of the amount of tile adhesive (height of the comb, thickness of the applied layer).
• Easy to use (assembly only requires a screwdriver).
• Adjustable notched trowel for glue easy to wash .
• Safe in transport (all edges except teeth are rounded).
• Durable, strong and rigid construction.

Before starting work

1. The device must be fixed to a flat surface that can be tightened, which will not scratch the tile (OSB board, wooden plywood, plasterboard, wooden top, etc.).
2. The device can also be attached to a table specially designed for this purpose, which is in a separate offer ( NetYou Table )
3. Set (tighten) the sides of the device to the ground, keeping the minimum clearance between the plate ( fixing screws included ).
4. Position (tighten) the comb over the plate. Place the comb on 1 mm feeler gauges before tightening ( feeler gauges included ).
5. If we apply glue to the tile with a comb - lift the comb stiffening bar .
6. If we apply the glue on the tile "smoothly" - lower the comb stiffening bar (remember about the 1mm gap above the tile).
7. After tightening all the screws, the plate should move freely back and forth.
8. Tighten the lower comb locks.

Assembly instructions (step by step)